LED warning lights

LED warning lights

Rechargeable LED Warning Lights

The Rechargeable LED Warning Lights are supplied in a case, as a set of 5. This sequential version of warning lights has the advantage of having a simplified sequential flash operating mode with a raised power button inside the case to active the sequence instantly for quick deployment. This provides a ‘flow’ effect of light as each Pod flashes in turn, designed for traffic control, signalling, hazard awareness, zone demarcations and vehicle safety.

Ideal for professional applications, including NDT, Police, Fire and Highway Services. Multiple cases of Pods can be ‘daisy chained’ together to produce long corridors of flashing light.

The Rechargeable LED warning lights are small but robust units are manufactured in shock resistant plastic housing, are waterproof (up to 10 metres) and virtually indestructible (withstanding most vehicle weights if crushed). Built in magnets allow attachment to vehicles or any metal surfaces.

Qty

Add to Quote

Description
Specifications

Visible from over 1 Kilometre
Rechargeable Li-ion battery
360° Illumination
9 Light modes + Sequential
Operates up to 60hrs & on sequential mode for 15hrs continuously
Waterproof up to 10m
Designed to meet IP65 rating
Floats in water
White torch setting
Led shows red when charging blue after 3 hours charge
Magnetic back
Working
Temperature -40° to 60°C

Operation: Press the switch, located near the front LEDs, once. Press again to change and cycle through the 9 modes.

To turn off the warning light without cycling through the 9-light pattern, press and hold the ON/OFF button for 2 seconds. Two LEDs will flash five times and then turn off. When ready to operate again, press the ON/OFF button once and it will return to the last flash pattern that was selected before turning off.

Sequential mode: Make sure the charger is disconnected. Place all pulsars into case, press button on case once and sequential mode will commence, remove pods from case and they continue to flash. To stop sequential mode, replace all pulsars back into case and press switch again.

Battery charging:

1) Place from 1 to 5 Pulsar into the pockets in the charging case lining the black charging input guides over the outputs. When placed correctly the (+) and (-) terminal symbols will be aligned. The Pulsar are held inside of the pocket by the magnet.

2) Plug the male end of the appropriate 12V or 240-100V Charging Adaptor into the power input socket in the charging case.

3) Plug the 12V or 240-100V Charging Adaptor into either a 12V car cigar socket or 240-100V wall socket. Blue LED light on case = Shows charger is connected. Red LED light inside Pulsar = Pulsars are charging. Blue LED light inside = Pulsars are charged. Green light on charger = Charging, Red light on charger = Charged

4) To close the lid while charging the units, make sure the cable sits within the slot provided. Warning: Do not expose the battery to excessive heat, to do so may cause an explosion. Do not use metal objects to short circuit the positive and negative end of the battery. Do not dispose of the battery in the domestic waste, please use the correct method of disposal. Do not solder directly on to the battery. Do not let the battery become wet or immerse the battery in water. Keep the battery away from children. The operating temperature range of the warning light’s battery: Charging: 0°C to 30°C / Discharging: -40°C to 60°C

General: There are no user serviceable parts in this unit. In case of any problems or questions please contact us. Do not shine the warning light directly into people’s eyes, as it may damage their eyesight.

LED warning lights

Related Product